Specification · project management · heritage

Architects & specifiers: correct the thermal behaviour where EWI cannot be installed

When panel-based insulation runs into a protected building, a historic centre, a property boundary or mouldings to preserve, the Pro-Tech® facade thermal corrector opens a route that keeps the appearance. We support your specification with the technical documentation and the backing of a prior moisture diagnosis.

When should you specify a thermal corrector rather than EWI?

You specify a facade thermal corrector when panel-based EWI is technically or regulatorily impossible: protected buildings and historic centres where the appearance must be kept, facades with mouldings (cornices, bands, surrounds) that panels would erase, or construction on a property boundary that rules out any added thickness. The continuous Pro-Tech® render is applied in low thickness, follows the relief and renews the appearance without distorting it.

The cases where the system makes the difference

  • Protected buildings and historic centres: the appearance, the relief and the reading of the facade are preserved, where panels would be refused.
  • Facades with mouldings: cornices, bands, sills and surrounds are kept, because the render follows the substrate instead of covering it with a rigid plane.
  • Property boundary / party walls: the low thickness avoids the encroachment that thick EWI would impose.
  • Singular points: reveals, slab edges and junctions can be treated continuously, with no break in the envelope.

Preserving the appearance: a specification issue

On heritage and in protected areas, the value of a project often rests on the faithfulness of the restored facade. The system is applied as a continuous coat, with no framework and no panels, and receives the Techdekor Green finish: the colour, texture and relief can be matched to the existing. The aim is not to hide the facade, but to correct its thermal behaviour while respecting its architectural language. Applied thickness always starts at 10 mm.

Moisture is treated before the thermal behaviour

A damp facade insulates poorly and degrades. Before any specification, we help you frame the prior moisture diagnosis: rising damp, infiltration, condensation. The system is applied only onto a dry substrate; correcting the thermal behaviour of a wet wall would merely mask the problem and compromise durability. This requirement protects your specification and the client.

What we bring, what we ask

What we bring

  • System technical documentation (ETA, product data sheets);
  • Specification support: drafting of the specification, finish choice, singular points;
  • Assistance on the prior moisture diagnosis;
  • References and Techdekor Green finish samples.

What we ask

  • A prior moisture diagnosis and a dry substrate;
  • A specification faithful to the positioning (thermal corrector);
  • The use of an approved applicator firm;
  • No performance value or subsidy announced without a source.

What we do not specify

Isoltech Green is the European importer and developer of the system, not its inventor. Pro-Tech® is a thermal corrector, never a substitute for a certified EWI system: its European certification is underway. Until we can prove it, we do not specify the replacement of a certified insulation. For a very low U-value target on a flat, regular facade with no thickness constraint, a conventional EWI system often remains the right choice — and we say so.

The gains in the order of 40 to 60% sometimes quoted are customer feedback, not a guaranteed performance. No subsidy is promised. See the thermal correction guide for the honest comparison between correction and EWI.
Specify with us

A project on a protected building or with mouldings?

Send us your case: we frame the feasibility, the prior diagnosis and the specification documentation.

See the thermal correction guide, the thermal science cluster, the thermal corrective render, as well as the product pages Pro-Tech® and Techdekor Green. Other trades: design offices, applicators, distributors.

Call — +351 927 917 736