Page · ground floor

Insulating a basement ceiling: floor comfort above

Why does correcting a basement ceiling improve comfort in the dwelling above?

Because the ground floor separates the heated dwelling from a cold space (basement, garage, crawl space). Without correction, this floor stays cold and so does the floor of the dwelling. By applying a Pro-Tech® thermo-active render to the underside of the basement ceiling, you slow the heat escaping downwards: the floor of the room above becomes more pleasant to touch. It is a comfort correction, carried out with no framework, on a sound and dry substrate.

The ground floor over an unheated space

A ground floor that sits above an unheated basement, garage or crawl space is one of the most common heat-losing surfaces of a building. The space below being cold, the floor stays cold, and this coolness carries over to the floor of the dwelling: cold feet, a feeling of discomfort at floor level, the temptation to heat more.

Treating this element from its underside — that is, at the ceiling of the basement — is particularly attractive: you work in the unoccupied space, without touching the dwelling's floor covering or disturbing the occupant above.

A continuous render applied on the underside

The correction consists of applying the Pro-Tech® thermo-active render directly to the underside of the basement ceiling, in a continuous coat. As on walls, the application is done with no framework, no added insulant and no mechanical fixings, by hand or sprayed, following the good-practice rules for renders and for the masonry substrate.

The correction thickness follows the system's benchmarks: 10 mm for correction and basic comfort, 15 mm for enhanced comfort, 20 mm for a particularly cold ceiling or an old building. The continuity of the render also lets it run up along the perimeter walls and treat the floor/wall junctions, where the cold concentrates.

Fire reaction in the space

In a space such as a basement or garage, the fire reaction of the finish matters. Pro-Tech® render is classified A2-s1,d0 to the EN 13501-1 standard — a material class among the least combustible, with very low smoke production and no flaming droplets.

A dry substrate is required

A basement is often a damp place: this is the point to watch on this job. Thermal correction is applied only on a sound, dry and non-running substrate, at a temperature above 5 °C, in a ventilated space.

To check before any application: no active rising damp, running water, salts or saltpetre on the ceiling and walls of the basement. Where moisture is present, you treat the cause first (drainage, barrier, ventilation) — applying a render on a damp substrate does not solve the defect. A prior diagnosis is essential.

A correction, not regulatory insulation

Treating the basement ceiling with a thermo-active render brings a comfort gain at the floor of the dwelling and limits the losses downwards. It is a thermal correction: it does not replace a full regulatory insulation of the ground floor and its performance depends heavily on the substrate. We publish no figured R/U/λ value attributed to a given element outside an identifiable report; the gains mentioned by customers (in the order of 40 to 60%) are customer feedback, not a laboratory proof or a guarantee.

This page is part of the interior thermal correction guide. See the neighbouring page on the floor between dwellings and the technical documentation.

Call — +351 927 917 736