Page · intermediate floor

Thermal correction of a floor between dwellings

Can a floor between two dwellings be thermally corrected?

Yes, by applying a Pro-Tech® thermo-active render to the underside of the floor, on the lower dwelling's side. It is useful when the dwelling above is little or not heated, or when an intermediate floor sits over an unheated space (shop, lobby, passage). The continuous render limits the losses downwards and improves contact comfort. It is a comfort correction, carried out with no framework, on a sound substrate — not a regulatory insulation.

When correcting an intermediate floor is useful

Between two dwellings heated in the same way, the loss through the floor is small: both volumes are at a similar temperature. Correction becomes relevant as soon as there is a temperature gap on either side:

  • upper dwelling little or not heated (second home, vacant unit) above an occupied dwelling;
  • floor above an unheated common space: lobby, covered passage, plant room, ground-floor shop;
  • floor above an open passage or an exposed porch.

In these situations the floor behaves like a heat-losing element: the floor of the heated dwelling stays cold and heat escapes towards the colder volume below.

Continuity of treatment on the underside

The correction is applied on the underside of the floor, in the lower space, which avoids working on the floor covering of the dwelling above. The Pro-Tech® thermo-active render is laid in a continuous coat, with no framework, no added insulant or mechanical fixings, by hand or sprayed, following the good-practice rules for renders.

Continuity is decisive here: the render covers the whole underside and runs up along the perimeter walls and cross walls, treating the floor/wall junctions where the cold concentrates. This cuts the flows at the links, in the same logic as the 1-metre return applied to cross walls. The correction thickness follows the system's benchmarks: 10 mm (basic), 15 mm (enhanced), 20 mm (very cold situation).

Installation benchmarks

ParameterBenchmark
Face treatedUnderside of the floor, on the colder space's side
Correction thickness10 mm (basic) · 15 mm (enhanced) · 20 mm (very cold)
JunctionsRun-up onto perimeter walls and cross walls
Fire reactionA2-s1,d0 (EN 13501-1)
SubstrateSound, dry, non-running · T > 5 °C · ventilated space

A sound substrate and a prior diagnosis

As with any interior correction, the substrate must be sound, dry and stable: a temperature above 5 °C, no running water, no active rising damp, salts or saltpetre. Where moisture is present, the cause is treated first. A prior diagnosis is essential to validate the substrate and the thickness.

Pro-Tech® on the underside of a floor is a thermal comfort corrector: it limits losses and improves the feeling underfoot, but it does not replace a regulatory insulation of the floor. No figured R/U/λ value is attributed to a given element outside an identifiable report; the gains mentioned (in the order of 40 to 60%) are customer feedback, not a guarantee.

This page is part of the interior thermal correction guide. See the neighbouring page on the basement ceiling and the thermal bridges guide.

Call — +351 927 917 736