Thermal inertia is a material's or wall's ability to store heat and then release it slowly. A heavy wall takes time to warm up and to cool down: it dampens and delays temperature swings, which smooths the indoor environment. It depends above all on the mass and specific heat of the material. It is a dynamic-state behaviour, very useful for summer comfort.
Inertia is not a single property but is read through several physical quantities:
Unlike thermal conductivity or thermal resistance, inertia belongs to the dynamic state (temperature varying over time), not the steady state.
The heat storable in a volume of material is calculated simply:
C = ρ · c · V (C in J/K, ρ in kg/m³, c in J/(kg·K), V in m³)The amount of heat exchanged for a temperature difference ΔT is then Q = C · ΔT. A thick, dense wall has a high C: it absorbs a lot of energy before its surface temperature moves, which explains the "mass" effect.
Two complementary effects are distinguished:
Summer comfort depends above all on the absorption inertia of the walls facing the inside: these are the ones that "soak up" the day's heat.
These markers, drawn from building-physics literature, place material families from the point of view of heat storage:
| Material | Indicative ρ·c — kJ/(m³·K) | Inertia |
|---|---|---|
| Stone, concrete | ≈ 1,700 – 2,300 | High |
| Solid brick, rammed earth | ≈ 1,200 – 1,600 | High |
| Solid timber | ≈ 600 – 900 | Medium |
| Plaster, plasterboard | ≈ 500 – 800 | Medium to low |
| Insulating wools and foams | ≈ 20 – 100 | Low |
The major role of inertia is summer comfort. A high-inertia wall absorbs heat during the day, which limits the rise of indoor temperature during the hot hours, then releases it at night. Coupled with night-time ventilation (over-ventilation with cool air), it allows this stored heat to be removed before the next day. This is the principle of massive old stone buildings, naturally cool in summer.
Inertia also stabilises the environment in mid-season and dampens the surges of heating or solar gains, which improves the perceived operative temperature.
This smoothing has two virtues. First it reduces the amplitude of the temperature swings felt over the day, which limits overheating episodes and makes the environment steadier. Then it delays the effect of outdoor stresses, so that the heat stored during the hot hours is only felt later, at a time when it can be removed. Inertia thus acts as a thermal flywheel: it does not prevent heat exchange, but it spreads it out over time and softens its peaks.
Inertia is assessed through the dynamic thermal characteristics of a wall, calculated under the EN ISO 13786 standard (dynamic thermal transmission). This standard defines, for a periodic stress, quantities such as:
In practice, this standardised calculation (often via a dynamic thermal simulation) is combined with, where relevant, in-situ monitoring of surface temperatures. A calculation value, a simulation result and a site observation are always distinguished.
This page complements the Thermal correction of facades guide.